[QUESTION] Direct Drive for 0.4 Nozzle profile about ender3

[sn4k3]

It's easy to do:

1. Clone "Creality Ender-3 Stock" profile
2. Change retraction settings to:
   

[sn4k3]

You can get them from Official creality filaments on PrusaSlicer, you just need to go to PrusaSlicer Wizard and select Ender3 Printer and it filaments and i think it will show up

[NovaViper]

Ah cool. Thanks for the info! Uh... how do I go and get the filament profiles for the machine?

[NovaViper]

Ah ok, thanks!

[Moxie1776]

Be careful with those settings, sometimes with length that hi it can cause your hotend to clog. Speed can be adjusted up too, I would play with those settings. You may want to try zlift starting at .2.

[sn4k3]

0.8mm is not that high. My settings are for v6 e3d setup similar to prusa, but of course there are no universal setting, adjust if needed

[Moxie1776]

0.8mm is not that high. My settings are for v6 e3d setup similar to prusa, but of course there are no universal setting, adjust if needed

If I go past .6 my all metal microswiss clogs...

[NovaViper]

0.8mm is not that high. My settings are for v6 e3d setup similar to prusa, but of course there are no universal setting, adjust if needed

If I go past .6 my all metal microswiss clogs...

I actually have a V6 and BMG (both are clones) setup with the BMG directly connected to the V6 and dual 5015 fans. The retraction length and speed is actually pretty normal for a V6, anything above 1mm is too much.