Feature request/idea: ability to define used BT adapter in the config about ruuvicollector

[Scrin]

A suitable config option actually exists already, the command.scan and command.dump found under the "Advanced configuration" section of the example config. You can set something like:

command.scan=hcitool -i hci1 lescan --duplicates --passive
command.dump=hcidump -i hci1 --raw

to use hci1 instead of the default (hci0). You can also set any other hcitool/hcidump options this way, if needed.

I'm not familiar with MiFlora plant sensors, but if reading them follows the same pattern (initiate a BLE scan on the adapter and then read everything that comes in), you can use the same BT dongle for both by setting the scan command blank:

command.scan=

This way the RuuviCollector will not initiate a scan itself, but rather just passively listen at all incoming messages on the device (assuming a suitable scan is initiated elsewhere).

Do either of these options suit your needs?

[coccobill1]

Those are actually both great options and fill my needs perfectly. Maybe add a short note about them in the docs? Thanks for the quick reply.

[Scrin]

Good to hear, I'll add an additional note about them soon-ish when I'm going through the documentation