Time is one hour behind about otgw-firmware

[PvdGulik]

Solved in v0.7.6, default set to CET.
And also the on/off Heartbeat blinking led,

Thanks!

[rvdbreemen]

fixed in v.0.7.6 and beyond

[rvdbreemen]

Check your settings page, there you can setup the correct timezone. It does DST correctly.

If you live in the NL, it should say: CET... To change the setting, just enter your timezone (3 letter), or, country (2 letter), or, the verbose version, like "Europe/Amsterdam".

[rvdbreemen]

I reopened, to wait for confirmation that it works correctly. @PvdGulik

[PvdGulik]

Sorry, but where in the settings page? There's no option... See picture.[cid:F6983424-0F20-4DEA-9736-292D7E52AA92] Thank you! vriendelijke groet, Pieter Op 21 feb. 2021 om 14:17 heeft Robert van den Breemen <[email protected]> het volgende geschreven:  Check your settings page, there you can setup the correct timezone. It does DST correctly. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub<#26 (comment)>, or unsubscribe<https://github.com/notifications/unsubscribe-auth/ACH4FIUKDLS5FHPPDDELY73TAEBVTANCNFSM4X56QSZQ>.

[rvdbreemen]

I think I know what's going on. Sorry about that. In the dev release there is a setting.
And I just found that sometimes there is DST and sometimes it's not.
It's under investigation.

Thanks for reporting this @PvdGulik

[PvdGulik]

Hello,

It seems that problem is not totally resolved.
This morning (ca. 9:30) after updating to lateste version 7.7,
the NTP timezone was CET,and time was correct.
Now, at 20:30 the timezone has changed by itself to Europe/Amsterdam and is one hour behind again....

[rvdbreemen]

Hi @PvdGulik thanks for reporting back. I am hunting that bug, not sure why it is happening. The simpel fact that it changes from CET to Europe/Amsterdam is telling me that it is switching to the default setting, which is now Europe/Amsterdam.

The one hour behind is really weird, as my timezone is setup exactly the same and reporting the correct time.

Hmmmm, what is going on.

[rvdbreemen]

@PvdGulik

Well, I changed around some stuff in the dev branch. Now it will not try to be smart anymore and detect the timezone. I will now just accept whatever you decide the Timezone is.

Could you please verify this version? Let me know if you need a binary to test it.
Thanks
Robert

[PvdGulik]

Yes, no problem to test. Where I can find the new version of the ino.bin?

[rvdbreemen]

Here it is:
OTGW-firmware.ino.bin.zip

[PvdGulik]

Hello Robert,

I installed the new bin, set Timezone to CET, and saved.
Time was 1 hour behind. Reboot.
After reboot Timezone is set back to Europe/Amsterdam, but time is correct.
I set timezone back to CET, save but won't reboot.

Report you the results tomorrow.

Pieter

[PvdGulik]

Hello Robert,

8:51 Time is incorrect (1 hour behind), and timezone is back to Europe/Amsterdam.

I'll wait a couple of hours, keep you informed of any changes.

[rvdbreemen]

Sounds like it is fixed so far ;-)