Print to a bluetooth device via rfcomm and printer.File() about python-escpos

[belono]

Hi @dubaleeiro .

I'm not an expert on this subjects, at all. But I will try to help you.

Have you managed to send some unfiltered text to the device from your terminal?.
Note that maybe you need to run it as sudo.

echo 'Hello World!\n' > /dev/rfcomm0

If the former worked, then you can send some escpos commands as raw bytes:

echo '\x1b\x45\x01' > /dev/rfcomm0
echo 'Hello World!\n' > /dev/rfcomm0

If your printer understands ESC/POS, then "Hello World!" should appear in bold.
Otherwise I would assume that your printer speaks a different dialect and therefore cannot use python-escpos to print to it.

[dubaleeiro]

Hi @belono , thank you very much for your hints!

I am not not sure if the printer understands ESC/POS, I will check that. In addition, I think I have another problem: I cant setup the rfcomm on my pi. When I send the commands suggested by you, command line keeps 'thinking' withou any result. I will dig it further...

[belono]

Hope you are success @dubaleeiro .

Let us know if you make any progress.
This could be interesting for the eventual incorporation of a Bluetooth printer connector in this library.

Cheers!!