Firmware 2.4.27 about udm-telus

[tylerdola]

Still works for me and I just updated to 3.0.19. The path locations are different though, there is no /mnt, just install direct to /data/igmpproxy and /data/on_boot.d

[tylerdola]

Actually I just updated to 3.0.19 and Network 7.4.149 and there is a built in IGMP Proxy via the IPTV support. No more need for this wonderful udm-telus. @peacey, appreciate all that you have done.

[tylerdola]

I had it working with this for a while and the igmpproxy shut off. It stopped working after a few hours, so I'm going to blame Ubiquiti and go back to the original set up.

EDIT: Its working with stock Unifi OS 3.0.19 with the built in IGMP proxy. I just had to make sure IGMP snooping was turned off.

[dslawdog]

I had it working with this for a while and the igmpproxy shut off. It stopped working after a few hours, so I'm going to blame Ubiquiti and go back to the original set up.

EDIT: Its working with stock Unifi OS 3.0.19 with the built in IGMP proxy. I just had to make sure IGMP snooping was turned off.

Just wanted to reach out and see if you've had continued success using the IPTV support button (vs all the config peacey did).

[tylerdola]

I had it working with this for a while and the igmpproxy shut off. It stopped working after a few hours, so I'm going to blame Ubiquiti and go back to the original set up.
EDIT: Its working with stock Unifi OS 3.0.19 with the built in IGMP proxy. I just had to make sure IGMP snooping was turned off.

Just wanted to reach out and see if you've had continued success using the IPTV support button (vs all the config peacey did).

Yes, it is still working! But I still followed peacey's awesome instructions for the VLAN creation. I just checked off the new IPTV support checkbox and ensured that IPTV vlan did not have IGMP snooping enabled.

[christohill]

@tylerdola Was there anything specific needed to get the IPTV Support checkbox to appear? I'm not seeing it and can't seem to figure out how to enable it.

Current versions UDM-SE (both say up to date):
Unifi OS: 3.0.18
Network: 7.3.83

[Jeremiah164]

@tylerdola Was there anything specific needed to get the IPTV Support checkbox to appear? I'm not seeing it and can't seem to figure out how to enable it.

Current versions UDM-SE (both say up to date): Unifi OS: 3.0.18 Network: 7.3.83

You need to be in early access to get it. I was able to get IPTV working great using this https://github.com/fabianishere/udm-iptv