Double events are fired for Philips Wall Modules & Philips Hue Dimmer Switch about zigbee-herdsman-converters

[inlet]

[hvorragend]

I have the same problem and have already mentioned it here #22073.

[inlet]

This seems to be related Koenkk/zigbee2mqtt#22073

[inlet]

As a temporary workaround I've added a debounce: 0.1 for the particular devices. However this give issues if you trigger the device without the interval rate

[Koenkk]

Try to remove all bindings under the frontend -> device -> bind page and reconfigure the device by pressing the yellow refresh icon on the about tab.

[inlet]

@Koenkk thanks so much 🙏! Yes this does solve the issue

[inlet]

Oops I was too quick with closing this issue.. removing all bindings and reconfigure the device doesn’t seem to help. Neither re-adding the device. Any help is appreciated, thanks in advance 🙏

[inlet]

Update:

The bind page (frontend -> device -> bind), contains 2 bindings. If I remove the last one everything works correctly. However, when I reconfigure it (yellow refresh icon), there are 2 bindings again and the events are triggered double again.

For now I just removed the last binding so there's only 1 binding with the coordinator. Hopefully this gives you a bit of contexts. Not sure what causes it, but it occurred after the latest z2m update. I tried to restore to a previous backup, but somehow the changes have been propagated to the zigbee network.