Not seeing output from any command about ilo4_unlock

[Crylia]

Never mind, I had to reset the ilo (that was probably meant with power off, not just shut down)

[brettinternet]

@kendallgoto I ran into this and had to reset the iLO. After rebooting I'm not seeing any output again. Do I have to reset the iLO each time I want to configure a fan?

</>hpiLO-> fan info



</>hpiLO->

[kendallgoto]

you have to reset iLO every time you want to see the output of the command, not every time you want to configure the fan itself. the commands still work even if the output isn't shown, it just isn't helpful for commands that only show information (like fan info).

also, on a single SSH session, the output will continue to work. it'll just stop working if you create a new ssh session.

[brettinternet]

I see, thank you for the help!