LC4500 Pattern Mode with libusb about slstudio

[jakobwilm]

Hello Nok,
first of all, we should be very accurate in what we mean by 'pattern sequence mode'. In your case, it appears that you want to store patterns in the firmware. While we have had some success with this approach, it is not the recommended way of operation (as mentioned in the README). In part this is because synchronization (which camera frame represents which pattern?) is difficult if the projector is operating autonomously. The other reason is that a change of patterns requires you to re-flash the firmware on LC4500. A third reason is that this makes it very complicated to correct for projector lens distortion (the patterns need to be pre-distorted before upload. Distortion parameters might vary between calibrations).
What you need to do is to choose a codec, write its patterns to disk (uncomment appropriate lines in the scanworker class), bake these into firmware, modify the LC4500 projector class code and choose exposure and timing values suitable for your specific camera (obeying its frame rate, trigger delay, time for frame transfer).
Regards Jakob