Throttle Range Inconsistent - Pentium40A about wii-esc

[GoogleCodeExporter]

I noticed that you guys switched to the C based version of the firmware in 
trunk. Is my Pentium 40A config included in there? I looking the HAL folder and 
did not see that it was ported. Does anyone have new compile/flashing 
instructions for the new firmware?

Original comment by [email protected] on 30 Aug 2012 at 12:04

[GoogleCodeExporter]

Hi,
For v1 you need:
1) calibrate oscillator using avrstudio
2) write calibration value to the last byte of eeprom
3) enable READ_CALIBRATION

In v2 there is automatic calibration.

Original comment by [email protected] on 30 Aug 2012 at 10:20

[GoogleCodeExporter]

Excellent... I would love to use v2 if possible. Two questions:

1. Do you have a link to compile/flashing instructions for v2?
2. Did you happen to include the Pentium 40 (inverted nFETs) hardware config in 
v2?

Original comment by [email protected] on 30 Aug 2012 at 2:16

[GoogleCodeExporter]

Easiest way to build:
1) Download Code::Blocks (in downloads)
2) Open project wii-esc-ng.cbp
3) Setup path to avr-gcc in Code::Blocks

Pentium 40, not included yet ;(

Original comment by [email protected] on 30 Aug 2012 at 10:21

[GoogleCodeExporter]

Hi,
I have added support for tp_nfet in branch.

Compilled hex:
http://wii-esc.googlecode.com/files/tp_nfet.zip

Be carefull during testing,

Original comment by [email protected] on 31 Aug 2012 at 2:24

[GoogleCodeExporter]

You rock!! I will try it out when I get back from vacation on Tuesday. 

I am also going to try to compile it with advance timing of 2 because my motors 
seem to need "high timing". I have AXI 2826/12 motors.... Low kv.

Original comment by [email protected] on 31 Aug 2012 at 2:33

[GoogleCodeExporter]

Noice... was able to get it compiled. I did not see any config options for 
timing advance. Is that on by default?

Original comment by [email protected] on 5 Sep 2012 at 3:09

[GoogleCodeExporter]

Hi,
The timing advance, currently, fixed to 15 deg. But I have adjusted 
compensation using oscilloscope, so it should work without tweaking. ;)

Original comment by [email protected] on 5 Sep 2012 at 11:16

[GoogleCodeExporter]

Heh... I am not sure what that means, but I will take your word for it. I plan 
on flashing this by Friday afternoon, so I will post back and let you know how 
it works. Soldering and flashing 8 ESCs takes a long time.

Original comment by [email protected] on 6 Sep 2012 at 2:18

[GoogleCodeExporter]

Original comment by [email protected] on 10 Sep 2012 at 9:24

• Changed state: Fixed

[GoogleCodeExporter]

Original comment by [email protected] on 20 Feb 2013 at 1:45

• Changed state: Verified