RF with Boradlink RM Pro+ not working about iobroker.broadlink2

[frankjoke]

Would be good to know which code the version has.
First, did you check and update the firmware (you can do it only with mobile)?
Second, is it working with the mobile to learn RF? If you can with sweep frequencies this is the special RF learn in the adapter.
Go into admin/object browser and look at the devices native config, tell us what's written in
"devtype": 10026,

The 10026 is mine (bought a year ago) and it is working well with RF. Sometimes it need to use sweep mode most of the time it works without.

Otherwise I cannot help because I just access the commands which I know from broadlink.

[Panoru84]

Hello Frank, (I'm also from Germany, but may be should keep in English if somebody else is searching for the same issue).

[pointia]

Hi,
I'm also facing the same issue. IR signals work just fine but RF is not working wherease the native app (ihc) knows the signal.

here are my device infos:

{ "common": { "name": "RM:broadlink-lan", "read": true, "write": true, "state": "state", "role": "level", "type": "boolean" }, "type": "state", "_id": "broadlink2.0.RM:broadlink-lan", "native": { "host": { "address": "192.168.1.80", "family": "IPv4", "port": 80, "size": 128, "devtype": 10141, "type": "rm", "name": "RM:broadlink-lan", "devname": "RM3 Pro Plus", "mac": "9d:27:50:1:a8:c0" } }, "from": "system.adapter.broadlink2.0", "ts": 1537612472200, "acl": { "object": 1638, "state": 1638 } }