Rpi2 60khZ frequency needs overclock about txtempus

[cnww-ns]

I just set this up on a headless Raspberry Pi 2 model B. It worked perfectly without overclocking, but I do not have a monitor connected. I suspect that may be the source if this issue.

I am available to run other tests if you'd like.

[ispire2]

Thank you. Appreciated. Will try again, just for curiosity;I am not running X though.. Can you get the 40 kHz signal ? That I could not get at all. Regards.

…

On Wed, Feb 17, 2021, 3:26 PM cnww-ns ***@***.***> wrote: I just set this up on a headless Raspberry Pi 2 model B. It worked perfectly without overclocking, but I do not have a monitor connected. I suspect that may be the source if this issue. I am available to run other tests if you'd like. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#12 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ADUQJAVYVKV6KO6JSH7UEM3S7QRAPANCNFSM4TXQPKUQ> .

[cnww-ns]

Sorry, I should have specified in my previous message that I'm using WWVB at 60KHz.

I do not have a 40KHz receiver to test it with, but based on the console output it appears to think that it's transmitting successfully when I ask it to use JJY40. Whether it actually is working is a whole other question.

[ispire2]

No worries. I checked the output on a scope. All my clocks are now perfect. Great work. Thanks again.

…

On Wed, Feb 17, 2021, 16:30 cnww-ns ***@***.***> wrote: Sorry, I should have specified in my previous message that I'm using WWVB at 60KHz. I do not have a 40KHz receiver to test it with, but based on the console output it appears to *think* that it's transmitting successfully when I ask it to use JJY40. Whether it actually *is* working is a whole other question. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#12 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ADUQJAQHVUATN3RANK6I7W3S7QYQJANCNFSM4TXQPKUQ> .