Raspberry Pi doesn't boot anymore after update about rpi-update

[amosk]

Similar results here. Solid red light after update and reboot.

[amosk]

Is is what I get from the serial port before the RPi stops:

[ 1.839298] usb usb1: Product: DWC OTG Controller
[ 1.846224] usb usb1: Manufacturer: Linux 3.2.27+ dwc_otg_hcd
[ 1.854094] usb usb1: SerialNumber: bcm2708_usb
[ 1.861664] hub 1-0:1.0: USB hub found
[ 1.867638] hub 1-0:1.0: 1 port detected
[ 1.874780] usbcore: registered new interface driver uas
[ 1.882128] Initializing USB Mass Storage driver...
[ 1.889363] usbcore: registered new interface driver usb-storage
[ 1.897536] USB Mass Storage support registered.
[ 1.904509] usbcore: registered new interface driver libusual
[ 1.912734] mousedev: PS/2 mouse device common for all mice
[ 1.921285] bcm2835-cpufreq: min=0 max=700000 cur=700000
[ 1.926741] bcm2835-cpufreq: switching to governor powersave
[ 1.934543] bcm2835-cpufreq: switching to governor powersave

[sklaus]

mmhh.

normally this is the sequence at this time:

[ 1.296403] usbcore: registered new interface driver libusual
[ 1.303329] mousedev: PS/2 mouse device common for all mice
[ 1.310463] bcm2835-cpufreq: min=700000 max=700000 cur=700000
[ 1.310742] bcm2835-cpufreq: switching to governor powersave
[ 1.317146] bcm2835-cpufreq: switching to governor powersave
[ 1.323665] cpuidle: using governor ladder
[ 1.336001] cpuidle: using governor menu
[ 1.342386] sdhci: Secure Digital Host Controller Interface driver
[ 1.348570] sdhci: Copyright(c) Pierre Ossman
[ 1.355126] sdhci: Enable low-latency mode
[ 1.361271] bcm_power_open() -> 1
[ 1.368016] Registered led device: mmc0::
[ 1.369464] mmc0: SDHCI controller on BCM2708_Arasan [platform] using platform's DMA
[ 1.376104] mmc0: BCM2708 SDHC host at 0x20300000 DMA 2 IRQ 77
[ 1.382569] sdhci-pltfm: SDHCI platform and OF driver helper
[ 1.389295] Registered led device: led0
[ 1.389720] usbcore: registered new interface driver usbhid
[ 1.397177] usbhid: USB HID core driver

[sklaus]

Ok, short update:

Seems that was an issue with my SD card image after the update.
reinstalled the SD card form scratch.

Not sure if the remaining space on the SD card was an issue.

So the RPi starts again.

I checked also the firmware with vcgencmd version, and indeed the firmware is updated from August 10 version 330751 to Sept 18, version337601