BC_LED_MODE_BLINK_* actual speed? about twr-sdk

[hubpav]

That is right, but actually we cannot say exactly how much is SLOW or FAST since it is configurable. These flashing / blinking states are defined by a so-called "patterns" which is simply alternating sequence of "1" and "0" where each bit in the mask represent a so-called "slot" - slot is by default 100 ms but can be changed using a "set_slot_interval" call. So if you have pattern 0xaaaaaaaa , then the LED will blink 100 ms ON and 100 ms OFF (typically). Using this you can do some fancy stuff like 0xa000a000 - means two short blinks and long delay between them. You do not have to use these predefined blink modes but there is also a call for the custom blinking pattern. Happy blinking! 😄