Enhancement: Display the cpuminer device ID on the dashboard about minera

[michelem09]

mmm I can't understand. Why do you need the device ID while you have the serial number and the device name?

[Iggyboo]

When you get any error or share result in the log it is referenced by that
enumerated ID as "ID#@chip#". I'm not sure I'm using the correct
terminology for that but that was the best way I could interpret it. It
would make it easier for tuning to have that designated on the dashboard at
every run so I can track down the offending chip and adjust the frequency.
I figure you already determine that "ID" initially since you can track
errors/rejects/accepted shares on the dashboard table.
On May 29, 2014 2:08 AM, "Michele Marcucci" [email protected]
wrote:

mmm I can't understand. Why do you need the device ID while you have the
serial number and the device name?

—
Reply to this email directly or view it on GitHubhttps://github.com//issues/29#issuecomment-44500960
.

[michelem09]

I'm sorry but I can't show that because you are talking about each single chip ID while Minera shows an aggregate device data (totals from each chip a device/board have). Then, the device/chip id isn't in the cpuminer-gc3355 API stats so I can't get it.