Having issues installing Marlin onto the Fysetc-Spider about fysetc-spider

[GerogeFu]

Sorry, this should be my fault, i just update the ini. You can have a try now.

[420Ayan420]

Alright I'll have a look now! Edit: The original Issue has been solved, but now this is the problem:

[420Ayan420]

I've done some further testing, and the same problem is still there @GerogeFu

[GerogeFu]

The version in our github is little bit old, please try Marlin upstream bugfix-2.0.x, i will fix this ASAP.

[420Ayan420]

Okay, I'll try and set that up later today, and thank you

[420Ayan420]

Alright everything has compiled successfully, I have uploaded the successfully compiled bootloader to the board using STM32CubeProgrammer, but once again the LCD does not turn on, nor does the board get detected by windows Device manager. Attached is my marlin folder with all my files and the success message:

Marlin-bugfix-2.0.x.zip

My STM32CubeProgrammer configuration:

File path: C:\Users\ayana\Desktop\Marlin\Marlin-bugfix-2.0.x (Cantilever)\Marlin-bugfix-2.0.x.pio\build\FYSETC_S6_8000\firmware.bin
Start Address: 0x08008000 (as I am using default_envs = FYSETC_S6_8000)

Also when uploading STM32CubeProgrammer says that everything has been uploaded with no issues, so I don't think that will be a problem.

[GerogeFu]

Did you change configuration.h file? The serial post should be -1.

[420Ayan420]

Yes, I have changed it to -1

[GerogeFu]

I test again. It works, you should upload bootloader https://github.com/FYSETC/FYSETC-SPIDER/blob/main/bootloader/Bootloader_FYSETC_SPIDER.hex. When uploading the firmware with stm32cubeprobrammer, you need to check the boot offset is right or not.

[GerogeFu]

I just update the Marlin firmware in our github.

[420Ayan420]

Alright, I will have a look in a few hours, by boot offset do you mean the Start Address being 0x08008000?

[GerogeFu]

Yes

Alright, I will have a look in a few hours, by boot offset do you mean the Start Address being 0x08008000?