Possible Issue in PinOut.SVG about fysetc-spider

[bigsubgit]

Hello, I'm starting now to studying the spider for my new 2.4, how could be a negative pole if there we put a jumper cap?

[bigsubgit]

Sorry, perhaps I was wrong in my previous post.

[GerogeFu]

All '+' is 12v/24v , and '-' is GND

[xenon2008]

All '+' is 12v/24v , and '-' is GND

Sure, but i mean the color on the first picture.... GND is RED?
and on the second Picture i think the in the Green & Blue Section "+" & "-" are reversed?

[GerogeFu]

No, the middle point is not GND, it is common point for jumper, so if you can close a jumper on 24v and the middle point or on 12v and the middle point. That means you can select voltage.

[GerogeFu]

Hello, I'm starting now to studying the spider for my new 2.4, how could be a negative pole if there we put a jumper cap?

jumper cap

[xenon2008]

No, the middle point is not GND, it is common point for jumper, so if you can close a jumper on 24v and the middle point or on 12v and the middle point. That means you can select voltage.

oh sorry my Mistake!
But it is also right that on the two Blue Ports the Voltage Pin is right?

[GerogeFu]

Stick to this: all '+' is 12v/24v, and all '-' is GND. Then you won't make mistake.