Goggles V1 and Air unit don't show the OSD after installing WTFOS stuff, dont show quad battery status and DJI assistant 2 show error: Cannot load firmware list (4-10) about wtfos

[ObiVanDunobi]

SOLVED
Dumb user :/
In CLI comands I didnt write SAVE so the CLI never saved up MSP settings.
But DJI assistant still didnt wok. I can live with that if I will never need DJI assistant 2 any more. Hope I will never need it again :D
Sorry for false issue.
Thak you
Juraj

[magizusebas]

Hello, i am having the exact same problem, but after saving the cli for MSP, i still cant see the betaflight osd, i dont know if you could help me or if you were able to find a way to connect to dji assistant 2

[ObiVanDunobi]

Hello, i am having the exact same problem, but after saving the cli for MSP, i still cant see the betaflight osd, i dont know if you could help me or if you were able to find a way to connect to dji assistant 2

Hi, make sure that you have all betaflight settings according to JB or Oscar Liang and your MSP port should be -1 from your actual UART where you have air unit soldered.
My OSD works well now.
I think you have to turn off Custom OSD in DJI Goggles.
For dji assistant, I dont use it any more.
Still not able to change firmware because of error message (Cannot load firmware list).
But there is a way how to able it again.
If you have installed WTFOS, you have to run one phrase at CLI.
See this from 5:30.
https://www.youtube.com/watch?v=vubarw7BJkw
Good luck and let me know 😉

[Chupokabra5]

The same thing doesn’t work at all I’ve tried the cli and the preset and 4.4

[Chupokabra5]

Betaflight 4.4*

[ObiVanDunobi]

Hi, I dont remember how I made it but its work for me now. I know I made a one mistake: I didnt hit the Save button after putting commands in CLI. So try to do all the steps again and dont forget save CLI commands. Let me know if it helps. Dňa so 4. 11. 2023, 9:06 Chupokabra5 ***@***.***> napísal(a):

…

Betaflight 4.4* — Reply to this email directly, view it on GitHub <#30 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/A3TYZKPHK3GDAQ2662XOMHDYCXZPTAVCNFSM6AAAAAARFR4IZGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMYTOOJTGM3TONJYGY> . You are receiving this because you modified the open/close state.Message ID: ***@***.***>