[BUG] MAXTEMP trigger when SD-Card print ends about marlin-ai3m-2.0.x

[SimGas]

I am sorry, but I just discovered one cause of the MAXTEMP trigger.
I did not reset the EEPROM after upgrading the firmware.

I have done that now. That caused the MAXTEMP trigger to not occur anymore.

However, Now I get a complete restart of the printer after each print job:

[...]
SENT: M105
READ: X:86.81 Y:94.96 Z:1.53 E:0.00 Count X:8138 Y:8138 Z:612
READ: ok T:220.13 /220.00 B:75.00 /75.00 @:42 B@:61
READ: X:92.47 Y:88.40 Z:1.53 E:0.00 Count X:7010 Y:7498 Z:612
READ: X:94.28 Y:86.81 Z:1.53 E:0.00 Count X:7398 Y:7072 Z:612
SENT: M105
READ: TFT Serial Debug: SD print done... J14
READ: DEBUG: AI3M Pause State: 0
READ: echo:SD card ok
READ: TFT Serial Debug: SD card inserted... J00
READ: DEBUG: Set filament trigger time
READ: start
READ: echo:Marlin 2.0.4.4
Marlin 2.0.4.4
READ:
READ: Marlin-AI3M v2.0.1
[...]`

[davidramiro]

Do you have your filament sensor connected?

[SimGas]

Yes, the filament sensor is still connected. Electrical-hardware-wise my printer is still unmodified. Am 11. April 2020 11:29:14 schrieb David Ramiro <[email protected]>:

…

Do you have your filament sensor connected? — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub, or unsubscribe.

[davidramiro]

Interesting. Mine is not connected and the printer does not restart after an SD print. The second debug message implies it gets triggered.

I have to test that sometime, but please excuse my response time. I don't have much time to spend on this project at the moment.

[SimGas]

If you want me to test something, just tell me. The bug is currently not a problem to me as I started using octoprint anyway :-) Am 11. April 2020 11:35:49 schrieb David Ramiro <[email protected]>:

…

Interesting. Mine is not connected and the printer does not restart after an SD print. The second debug message implies it gets triggered. I have to test that sometime, but please excuse my response time. I don't have much time to spend on this project at the moment. — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub, or unsubscribe.

[github-actions]

This issue is stale because it has been open 30 days with no activity. Remove stale label / comment or this will be closed in 5 days.