EEPROM support? about arduino-tiny

[GoogleCodeExporter]

If you want to have an effect you will have to provide a better description of 
the symptom than "does not work".

Original comment by [email protected] on 21 Feb 2012 at 9:45

[GoogleCodeExporter]

Code is this.

Power on count up,
if shutdown ,after reboot still continue count up.

----------------------------------------------------
//memory count up and SEND

#include <SoftwareSerial.h>
#include <EEPROM.h>
SoftwareSerial mySerial(0,1); 
int i=0;          
int val;

void setup() {
  mySerial.begin(9600);  // RX:0 TX:1
  val = EEPROM.read(i);  //EEPROM read
 }

void loop() {
  val=val+1;
  EEPROM.write(i, val);
  mySerial.println(val) ;  //send
  delay(500);             
 }

Original comment by [email protected] on 21 Feb 2012 at 10:17

[GoogleCodeExporter]

Looking around for a an exmaple how to use the EEPROM of my attiny85 I came 
across this issue. The code in comment #2 works fine with the current version 
of arduino-tiny on an attiny85.

Original comment by qistoph on 20 Sep 2012 at 8:25

[GoogleCodeExporter]

[deleted comment]

[GoogleCodeExporter]

You need to read back eeprom after writing it. I would also put a delay(5) 
after writing to give the eeprom circuits time to complete the write command. 

void loop() {
  val=val+1;
  EEPROM.write(i, val);

  delay(5);
  val = EEPROM.read(i);  //EEPROM read

  mySerial.println(val) ;  //send
  delay(500);             
 }

Original comment by [email protected] on 16 Jul 2015 at 12:08