ia6c firmware about flyskyrxfirmwarerssimod

[Cleric-K]

Hi,
I guess the firmware is somewhat similar to the x6b and ia6b, so I hope it won't be too hard.
I don't have such a rx so the questions are:

• what mcu it uses
• does it expose the swclk and swdio pins to pcb pads
• does this rx sends telemetry? Does it send "signal strength" telemetry?

If you are able to dump the existing firmware with stlink I can take a look.

[jotaemesousa]

Hi! Yes the receiver uses a STM32F03 (like you can see here http://rc-aviation.ru/images/obzor/apparatura/TGY-iA6C-3.jpg).
The board has the SWD pins exposed, so it won't be a problem to flash.
I has the receiver mounted on my quad, so I will send you a dump of a firware that exists (https://github.com/povlhp/FlySkyRxFirmware/blob/master/firmwares/iA6C.bin).

I program these type of microcontrollers at work, but I am not an assembly expert, so if you need so help I can test the firmware or help you to find the solution. Moreover, this receiver has a method of Auto-bind, so maybe it will be a little diferenf from the x6b.

[Cleric-K]

Hi, I looked at the binary you sent me and it is quite similar to the other ones, so making the patch was relatively easy. I don't have a way to test it so I really hope I didn't mess anything up.

Check out IA6C_rssi.zip.

!!! Don't forget Backup your current firmware !!!

If it turns out to be working I'll include this in the project.

[jotaemesousa]

Hi, good news! It works on ia6c, I only tested on betaflight, but I think it is ok (when flying).
Thanks a lot.

[Cleric-K]

Great! I'm glad it worked out!
I've pushed the source code.

Enjoy!