ESP8266 Chip sync error about btt-writer-v1.0

[pimchest]

I tried all possible drivers and checked the connection quality, but it still does not respond.

[ivt18]

I have the same problem as you, and I haven't been able to fix it thus far. Have you managed to get it working?

[ciro1138]

This issue is also happening to me. I tried replacement also the same issue.

[pimchest]

@IliyanVT18 @ciro1138 As it turned out, the operation was successful. But the terminal throws an error. Try to check the presence of a Wi-Fi network after execution, I discovered this completely by accident, you cannot completely trust the instructions.

[ciro1138]

@pimchest you were correct it was working I hadn't tested it because of the failure.

So I have an issue because the default IP is 192.168.0.1 and it set to static I cannot access the wifi page because it is in conflict with my router main page. Anyone have any ideas on how to reset this WiFi module. I tried to reflash and erase no luck.

[nebakanezzer]

btt writer seems not ready for prime time. tested this with 5 esp8266 chips and only one would connect, but not does not broadcast ssid after uploading an icon file (from the suggested sources). the other 4 it can't connect to at all.

[pimchest]

@pimchest you were correct it was working I hadn't tested it because of the failure.

So I have an issue because the default IP is 192.168.0.1 and it set to static I cannot access the wifi page because it is in conflict with my router main page. Anyone have any ideas on how to reset this WiFi module. I tried to reflash and erase no luck.

You should have another Wi-fi network that is not connected to the router. This network will be distributed by the module itself.
There should be no problem with IP address conflicts.

[Garydjc]

Hello.
Very, Very, true. It shows FAIL over and over even when I changed the baud rate to 115200. HOwever, I disconnected the module, plugged it into my LCD and sure enough, it's broadcasting a network connection called ESP3D!!!
Thank you!!!