Board does not boot anymore about bigtreetech-skr-v1.3

[SirPlotalot]

No, had to buy a new board.... Sorry bro signorecello <[email protected]> schrieb am So., 13. Okt. 2019, 14:43:

…

Hi, did you solve the problem? I'm having the same issue... — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#20?email_source=notifications&email_token=AL67S2QAPYO3FIVWUT4VNHTQOMJYVA5CNFSM4HJ44A42YY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOEBCVPWQ#issuecomment-541415386>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/AL67S2WB6OGJWNUUNIOQV23QOMJYVANCNFSM4HJ44A4Q> .

[ArturNadolski]

Did You check fuses?

[SirPlotalot]

Hello !
As i wrote, yes. Both.

[ArturNadolski]

Disconnect all connectors, remove stepstics and connect directly to PC (switch jumper to USB +5V).
If You can't connect via serial port try to use board UART directly (AUX-1) to PC or by OctoPrint/ESP3D.
If mainboard is OK You should get some information on console.

[SirPlotalot]

Hello Artur,
connected the board via UARt to Octoprint. Trying to connect fails because no manual baudrate works, Auto baudrate brings up this :

Connecting to: /dev/ttyAMA0Changing monitoring state from "Offline" to "Opening serial port"Connected to: Serial<id=0x6abad110, open=True>(port='/dev/ttyAMA0', baudrate=115200, bytesize=8, parity='N', stopbits=1, timeout=10.0, xonxoff=False, rtscts=False, dsrdtr=False), starting monitorStarting baud rate detection...Changing monitoring state from "Opening serial port" to "Detecting baudrate"Trying baudrate: 115200

[archikkk]

Hello, did you have config for ender5? I got new skr1.3 but it wont bootup eith mine config, can you please give yours to try

[SirPlotalot]

yes sure. Am Sa., 18. Mai 2019 um 16:00 Uhr schrieb archikkk <[email protected]

…

: Hello, did you have config for ender5? I got new skr1.3 but it wont bootup eith mine config, can you please give yours to try — You are receiving this because you authored the thread. Reply to this email directly, view it on GitHub <#20?email_source=notifications&email_token=AL67S2SZXVMFYTCHASPA2J3PWADWNA5CNFSM4HJ44A42YY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGODVWPFNY#issuecomment-493679287>, or mute the thread <https://github.com/notifications/unsubscribe-auth/AL67S2VGRRUVNO6PLP2CMZDPWADWNANCNFSM4HJ44A4Q> .

[signorecello]

Hi, did you solve the problem? I'm having the same issue...

[jairov4]

looks like some boards have the EXP1 and EXP2 bad oriented, check the pinout to confirm.
In my case, I had to cut the slot space to allow my cable to connect correctly oriented.