Feature request: Power on gcode about moonraker

[Arksine]

This isn't possible. Klipper cannot execute gcode macros when it is in the shutdown state, this is part of the reason why Moonraker has a "power" plugin. You will have to toggle power from Fluidd.

[wormiedk]

Would it be possible for the power plug-in to issue a restart command after a short delay when the printer is powered on?

[Arksine]

It could perhaps be made an option. I'll look into it.

[wormiedk]

That would be great. Maybe also a shutdown command :)

[Arksine]

Klipper will automatically enter shutdown when the mcu is disconnected

[dushyantahuja]

This would be really helpful - firmware_restart is required after switching on the printer to ensure the TMC drivers are initialised properly. I believe klipperscreen does something similar. Regards

…

On Sun, 24 Jan 2021, 16:45 Eric Callahan, ***@***.***> wrote: It could perhaps be made an option. I'll look into it. — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#71 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABQ6SCITIHFSA2YJFDXSQCLS3P6NHANCNFSM4WNINXYQ> .

[Arksine]

It is now possible to configure a [power] device to perform a FIRMWARE_RESTART after power on. See the restart_klipper_when_powered and restart_delay options in configuration.md.

[dushyantahuja]

That's great. Thanks a lot.

…

On Wed, 27 Jan 2021, 17:40 Eric Callahan, ***@***.***> wrote: Closed #71 <#71>. — You are receiving this because you commented. Reply to this email directly, view it on GitHub <#71 (comment)>, or unsubscribe <https://github.com/notifications/unsubscribe-auth/ABQ6SCPQOZJUOL4TNWAE23LS377C3ANCNFSM4WNINXYQ> .