Error on post-process (estimate working fine) about klipper_estimator

[dalegaard]

Thanks for reporting this. New version is going up with this fixed.

[jankolkmeier]

Not sure if relevant, but here is the result of dump_config:

{
  "max_velocity": 400.0,
  "max_acceleration": 5000.0,
  "max_accel_to_decel": 2500.0,
  "square_corner_velocity": 5.0,
  "instant_corner_velocity": 1.0,
  "move_checkers": [
    {
      "axis_limiter": {
        "axis": [
          0.0,
          0.0,
          1.0
        ],
        "max_velocity": 15.0,
        "max_accel": 120.0
      }
    },
    {
      "extruder_limiter": {
        "max_velocity": 60.0,
        "max_accel": 2078.758440383939
      }
    }
  ],
  "firmware_retraction": {
    "retract_length": 0.5,
    "unretract_extra_length": 0.0,
    "unretract_speed": 40.0,
    "retract_speed": 40.0
  }
}

[dalegaard]

This is caused by firmware_retraction so yes the config was very helpful 😊